Ring Wired Doorbell (2nd Gen) - Installation Instructions - Setup

Nov 4, 2026

Wired Doorbell (2nd Gen) installation guide that lists hardware and tools, then walks through the setup sequence: remove protective wrap, download the Ring app, and scan the in-device QR code. It instructs shutting off power at the breaker, provides safety cautions about electrical wiring and DC intercom systems, and details bypassing extra chimes. The guide continues with terminal screw steps, mounting bracket placement, wiring connection, security screw tightening, and restoring power.

LanguageEnglish

CategoryTechnology

FormatPDF

Pages6

Reading Time15 min

AccessFree to download

Doorbell installation

What you need

Step-by-step setup

Wired Doorbell (2nd Gen) | 1 EN | Hardware included | | | Tools needed | | | --- | --- | --- | --- | --- | | | | |
Phillips-head screwdriver | | | | | | Drill with a 1/4 in (6 mm) masonry bit (optional) | | | 1.
Remove the protective wrap.
| | | 2.
Download the Ring app.
| | Wired Doorbell (2nd Gen) | 2 EN 3. Scan the QR code on your device. Doorbell installation 1. Shut off power at the breaker. NOTE: If you are unsure which breaker to flip, turn off the master breaker or contact an electrician. CAUTION! You’ll be working with electrical wires during the install process. If you are uncomfortable or inexperienced with doing so, consult with a licensed electrician. Do not wire your Ring Doorbell to a DC-powered intercom system. WARNING! If your home has multiple chimes, you will need to ensure any additional chimes are bypassed by connecting the wires connected to Front and Trans together with a wire nut. 2. Remove your doorbell chime’s cover. 4. Connect one end of the bypass cable to the Front terminal, and the other to the Trans terminal. Wired Doorbell (2nd Gen) | 3 EN 3. Loosen the Front and Trans terminal screws. Make sure to keep the existing doorbell wires in place. 5. Re-tighten the terminal screws. Wired Doorbell (2nd Gen) | 4 EN 6. Locate your existing doorbell and remove. 7. Use the mounting bracket as a guide to mark screw holes on the wall. 8. Install the mounting bracket directly over your doorbell wiring with the Note: On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to included screws. drill holes for the included wall anchors. 9. Connect the doorbell wiring to your doorbell’s wire terminals. 11. Tighten the security screw. Wired Doorbell (2nd Gen) | 5 EN 10. Mount your doorbell by hooking it over the bracket. 12. Restore power at the breaker. Wired Doorbell (2nd Gen) | 6 EN [ring.com/contact](ring.com/contact)[ ](ring.com/contact) [ring.com/help](ring.com/help) Ring LLC 12515 Cerise Ave, Hawthorne, CA, 90250 USA ©2026 Ring LLC or its affiliates. Ring and all related marks are trademarks of Ring LLC or its affiliates.

FAQs

What safety steps are required before installing the Wired Doorbell (2nd Gen)?

Shut off power at the breaker. Consult a licensed electrician if unsure, and do not wire the doorbell to a DC-powered intercom system.

How do I handle a home with multiple chimes?

Bypass additional chimes by connecting the wires connected to Front and Trans together using a wire nut.

What is the final step after wiring and mounting?

Mount the doorbell by hooking it over the bracket, tighten the security screw, then restore power at the breaker.

Nov 4, 2026

Uploaded by How to eat