Paper Folding Test - Vz-2-BRACE Version 07 - Sample and Instructions

Sep 27, 2026

Uploaded by pop out

Paper Folding Test - Vz-2-BRACE Version 07 provides an assessment of spatial reasoning through the folding and unfolding of paper. Each question presents folded configurations on the left side of a vertical line and corresponding hole positions on the right after full unfolding. The test explains how punched holes pass through all paper thicknesses and instructs choosing the correct right-side figure and marking it with an X. It also specifies that participants complete Part One and Part Two within three minutes each, without moving or turning the paper between folds.

LanguageEnglish

CategoryExam

FormatPDF

Pages3

Reading Time8 min

AccessFree to download

Instructions

Sample Problem

Part One (3 Minutes)

Part Two (3 Minutes)

Paper Folding Test―Vz-2-BRACE In this test you are to imagine the folding and unfolding of pieces of paper. In each problem in the test there are some figures drawn at the left of a vertical line and there are others drawn at the right of the line. The figures at the left represent a square piece of paper being folded, and the last of these figures has one or two small circles drawn on it to show where the paper has been punched. Each hole is punched through all the thicknesses of paper at that point. One of the five figures on the right of the vertical line shows where the holes will be when the paper is completely unfolded. You are to decide which one of these figures is correct and draw an X through that figure. Now try the sample problem below. (In this problem only one hole was punched in the folded paper) . A B C D E The correct answer to the sample problem above is C and so it should have been marked with an X. The figures below show how the paper was folded and why C is the correct answer. | | | --- | | | In these problems all of the folds that are made are shown in the figures at the left of the line, and the paper is not turned or moved in any way except to make the folds shown in the figures. Remember, the answer is the figure that shows the positions of the holes when the paper is completely unfolded. Some of the problems on this sheet are more difficult than others. If you are unable to do one of the problems, simply skip over it and go on to the next one. You will have three minutes for each of the two parts of this test. Each part has one page. When you have finished Part One, STOP. Please do not go on to Part Two until you are asked to do so. DO NOT TURN THIS PAGE UNTIL ASKED TO DO SO PART ONE (3 MINUTES) 1 2 3 4 5 6 7 8 9 10 A B C D E STOP DO NOT PROCEED TO THE NEXT PAGE UNTIL ASKED TO DO SO PART TWO (3 MINUTES) 11 12 13 14 15 16 17 18 19 20 A B C D E STOP AND WAIT FOR FURTHER INSTRUCTIONS DO NOT GO BACK TO PART ONE

FAQs

What is the main task in the Paper Folding Test?

Imagine folding and unfolding paper and determine which right-side figure shows the hole positions when the paper is fully unfolded.

How should you mark the correct answer?

Draw an X through the figure that correctly matches the unfolded hole positions.

How is the test structured and how much time is given?

The test has two parts. Part One and Part Two each take three minutes, with separate pages and stop instructions between parts.

Sep 27, 2026

Uploaded by pop out

Paper Folding Test - Vz-2-BRACE Version 07 - Sample and Instructions_Page 1

Open in WPS to view all 3 pages