JACUZZI SWIM SPA COLLECTION - OWNER’S MANUAL - 1005244 Revision C - Attention New Swim Spa Owner

Oct 22, 2026

Uploaded by Liam

Owner guidance for the Jacuzzi swim spa collection, covering automated functions and first-24-hour precautions, with emphasis on maintaining healthy water chemistry. Specifies target ranges for pH, free chlorine/bromine, alkalinity, and calcium hardness, and explains the CLEARRAY Active Oxygen water management system including annual bulb replacement. Provides required filter cleaning cadence, routine water replacement every three months, and indicators for when replacement is needed. Includes key safety, location, electrical, filling, features, operation, maintenance, water quality, troubleshooting, and wiring references.

LanguageEnglish

CategoryHealthcare

FormatPDF

Pages64

Reading Time2 h 41 min

AccessFree to download

Table of Contents

Important Swim Spa Owner Information

Warnings

Important Safety Instructions for all Swim Spa Owners

Choosing a Location

General Electrical Safety Instructions

Electrical Installation Instructions (230 / 240 Volt Service)

Power Requirements

Swim Spa Fill Up Procedure

Spa Features

Swim Spa Operation

Pro X Current Control

Swim Spa Maintenance

Water Quality Maintenance

Error / Display Messages

Troubleshooting Procedures

Typical Swim Spa Wiring Diagrams

Circuit Board Wiring Diagrams

􀁸 J-13™ -PowerPlay™ 􀁸 J-16™ -PowerAcƟve™ 􀁸 J-19™ -PowerAcƟve™ 􀁸 J-16™ -PowerPro® 􀁸 J-19™ -PowerPro® JACUZZI® SWIM SPA COLLECTION OWNER’S MANUAL 1005244 Revision C AƩenƟon New Swim Spa Owner CongratulaƟons on the purchase of your new Jacuzzi® swim spa. The following is a list of automated funcƟons performed by your swim spa. These funcƟons are listed below in anaƩempt to suppress any operaƟonal concerns you may have during the ﬁrst 24 hours of ownership. Also listed below are important maintenance recommendaƟons you should observe on a regular basis to protect your new investment. Maintain Healthy Swim Spa Water Always maintain your swim spa’s water chemistry within the following parameters: | | With CLEARRAY® ACTIVE OXYGEN | Without CLEARRAY® ACTIVE OXYGEN | | --- | --- | --- | | pH | 7.4—7.6 | 7.4—7.6 | | Free chlorine | No less than 1.0 ppm | 3.0—4.0 ppm | | Free bromine | No less than 2.0 ppm | 2.0—4.0 ppm | | Total Alkalinity | 100—150 ppm | 100—150 ppm | | Calcium Hardness | 150—250 ppm | 150—250 ppm | IMPORTANT: CLEARRAY® ACTIVE OXYGEN Water Management System is factory installed. If the CLEARRAY® ACTIVE OXYGEN system is altered or is not operaƟng eﬃciently then follow the “without CLEARRAY® ACTIVE OXYGEN water chemistry parameters as deﬁned by the AssociaƟon of Pool and Spa Professionals. CLEARRAY® ACTIVE OXYGEN requires an annual bulb replacement to properly saniƟze your water. TO DECREASE RISK OF INFECTION OR DISEASE! Always maintain your spa ﬁlters as outlined below to ensure healthy spa water. Required Filters Maintenance Your new swim spa is equipped with an advanced water ﬁltraƟon system that provides unsurpassed water quality! To ensure maximum water quality at all Ɵmes, you should clean the skimming ﬁlter cartridge every 3 months, or as necessary. Required Water Replacement You should replace the swim spa’s water every 3 months. The frequency depends on a number of variables including frequency of use, number of users and aƩenƟon paid to water quality maintenance. You will know it is Ɵme for a change when you cannot control sudsing and/or you can no longer get the normal feel or sparkle to the water, even though the key water balance measurements are within the proper parameters. 2 © Jacuzzi Hot Tubs, Inc. All Rights Reserved Table of Contents 1.0 Important Swim Spa Owner InformaƟon 5 2.0 WARNINGS 5 3.0 Important Safety InstrucƟons for all Swim Spa Owners 9 3.1 Important Safety InstrucƟons 12 4.0 Choosing a LocaƟon 12 4.1 Outdoor LocaƟon 13 4.2 Indoor LocaƟon 14 5.0 General Electrical Safety InstrucƟons 15 6.0 Electrical InstallaƟon InstrucƟons (230 / 240 Volt Service) 15 7.0 Power Requirements 18 8.0 Swim Spa Fill Up Procedure 18 9.0 Spa Features 24 9.1 J-13™ PowerPlay™ Swim Spa Features 24 9.2 J-16™/J-19™ PowerAcƟve™ Swim Spa Features 25 9.3 J-16™ /J-19™ PowerPro® Swim Spa Features 26 10.0 J-13™ Swim Spa OperaƟon 27 11.0 J-16™ / J-19™ Swim Spa OperaƟon 33 11.1 Main Screen 33 11.2 NavigaƟon 35 11.3 The Swim Spa Screen 35 11.4 The Seƫngs Screen 38 11.5 Swim Spa Behaviour 42 11.6 Time of Day 43 11.7 AdjusƟng FiltraƟon 44 11.8 Light Cycle OpƟon 45 11.9 RestricƟng OperaƟon 46 12.0 Pro X Current Control 47 12.1 Manual Workout Mode 47 12.2 Timed Workout Mode 47 12.3 Workout Program Mode 48 13.0 Swim Spa Maintenance 49 13.1 Cleaning the Filter Cartridges 13.2 Waterfall Control Filter 50 13.3 Draining and Reﬁlling 50 13.4 Cleaning the Swim Spa Interior 51 13.5 Pillow Care 51 13.6 Maintaining the SyntheƟc Cabinet 52 13.7 Cleaning the Control Panel 52 13.8 Cover Care and Maintenance 52 13.9 Winterizing 53 13.10 StarƟng Your Swim Spa in Cold Weather 54 14.0 Water Quality Maintenance 54 14.1 pH Control 55 14.2 SaniƟzing 55 14.3 Other AddiƟves 56 14.4 CLEARRAY® ACTIVE OXYGEN Water Management System 56 15.0 Error / Display Messages 56 16.0 TroubleshooƟng Procedures 59 17.0 Typical Swim

FAQs

What water chemistry parameters should be maintained for the swim spa?

Maintain pH at 7.4–7.6 and follow the specified sanitizer levels for your system (with CLEARRAY Active Oxygen or without). Also keep total alkalinity at 100–150 ppm and calcium hardness at 150–250 ppm.

How often should the CLEARRAY Active Oxygen system be serviced?

The CLEARRAY Active Oxygen system requires an annual bulb replacement to properly sanitize the water.

How frequently should the swim spa filters be cleaned and the water be replaced?

Clean the skimming filter cartridge every 3 months or as needed. Replace the swim spa water every 3 months, based on use and water quality maintenance.

Oct 22, 2026

Uploaded by Liam