Glass Fabrication Template - Z-Series Square Type Flat Base Clamps

Oct 28, 2026

Upload by Connor

This technical document serves as a comprehensive glass fabrication template for the Z-Series square-type flat base clamps, specifically the Z934 model. It provides precise engineering specifications for installing 3/4-inch (19 mm) thick glass panels. The documentation details crucial measurements for the required glass finger slot, including a 7/8-inch (22.2 mm) diameter requirement, as well as the standard recommended gap between the glass edge and the post. Additionally, the manual outlines the use of 5/16-inch steel pins and rubber gaskets for secure support. Designed for use with square tubing or other flat surface architectural applications, these technical guidelines ensure structural integrity and accuracy for glass railing or partition installations. The document includes detailed cross-sectional views and technical schematics, emphasizing that project dimensions should not be scaled from the drawing, but strictly followed according to the provided numerical specifications for 316 stainless steel hardware components.

LanguageEnglish

CategoryTechnology

FormatPDF

Pages1

Reading Time3 min

AccessFree to download

Z-Series Square Type Flat Base Glass Clamp Fabrication

Technical Specifications and Requirements

Glass Fabrication Dimensions

Assembly Components and Installation Guidelines

FAQs

What is the required glass thickness for the Z934 glass clamp?

The Z934 glass clamp is specifically designed for use with 3/4-inch (19 mm) thick glass.

What is the standard recommended gap between the post and the edge of the glass?

The standard recommended gap between the post and the edge of the glass is 13/16-inch (20.6 mm).

What fabrication is needed on the glass to accommodate the steel pin?

A 7/8-inch (22.2 mm) diameter finger slot must be fabricated in the glass to accommodate the required 5/16-inch steel pin for glass support.

Oct 28, 2026

Upload by Connor