Bosch EDC16UC40 XROM MPC562 EGPT Deutz - ECU Connection Guide

Oct 25, 2026

Upload by Riley

This technical document provides a comprehensive connection guide for the Bosch EDC16UC40 ECU, specifically utilizing the XROM MPC562 processor interface via the EGPT protocol for Deutz engine control units. It includes precise pinout diagrams for the ECU connector, identifying key terminal assignments such as GPT0, GPT1, K-Line, Ground, and +12V power supply. The guide further illustrates the required hardware configuration, detailing the use of F34NTA22 ribbon cables and associated connection harnesses, such as the F34NTA22-S1, F34NTA22-S2, and F34NTA22-S3 models, to establish a stable and accurate connection between the electronic control unit and the diagnostic interface. This resource is essential for technicians performing bench programming or ECU communication, ensuring correct wiring implementation to prevent hardware damage and facilitate seamless data transfer during maintenance or tuning procedures.

LanguageEnglish

CategoryTechnology

FormatPDF

Pages2

Reading Time5 min

AccessFree to download

ECU Connector Pinout

Hardware Configuration and Cabling

FAQs

Which pins on the Bosch EDC16UC40 must be connected to +12V?

Pins 5 and 28 should be connected to the +12V power supply.

What is the purpose of Pin 2 on the ECU connector?

Pin 2 is designated for the Ground (GND) connection.

What hardware components are required for the connection?

The setup requires the F34NTA22 interface, an S1 connection cable, and either an F34NTA22-S3 (20 cm) or F34NTA22-S2 (60 cm) wiring harness.

Oct 25, 2026

Upload by Riley