1997 Bombardier Watercraft Shop Manual - Safety Notice and Table of Contents - Technical Service Guide

Oct 23, 2026

Upload by lilac

1997 Bombardier Sea-DOO watercraft shop manual covering models SP 5879, SPX 5834/5661, XP 5662, GS 5621, GSI 5622, GSX 5624, GTS 5818, GTI 5641, GTX 5642, and HX 5882. Includes safety notice guidance for trained technicians, required use of proper hand tools and special service tools, warnings for injury risk, cautions for component damage, and notes for completing instructions. Provides a detailed table of contents spanning maintenance, troubleshooting, engine, cooling, fuel, lubrication, electrical, propulsion, steering, suspension, hull/body, technical data, and wiring diagrams.

LanguageEnglish

CategoryTechnology

FormatPDF

Pages372

Reading Time15 h 37 min

AccessFree to download

Safety Notice

Introduction

Table of Contents

01 Maintenance

02 Troubleshooting

03 Engine

04 Cooling System

05 Fuel System

06 Lubrication System

07 Electrical System

08 Propulsion System

09 Steering System

10 Suspension

11 Hull/Body

12 Technical Data

13 Wiring Diagrams

[www.SeaDooManuals.net](www.SeaDooManuals.net) ® SHOP MANUAL 219 100 048 [www.SeaDooManuals.net](www.SeaDooManuals.net) Legal deposit: National Library of Quebec National Library of Canada All rights reserved. No parts of this manual may be reproduced in any form without the prior written permission of Bombardier Inc. © Bombardier Inc. 1996 Printed in Canada ® *Registered trademarks of Bombardier Inc. Loctite® is a trademark of Loctite Corporation Snap-on® is a trademark of Snap-on Tools Corporation Gelcote® is a trademark of Gelcote International Limited [www.SeaDooManuals.net](www.SeaDooManuals.net) | TABLE OF CONTENTS | | | | | --- | --- | --- | --- | | SECTION | SUB-SECTION | | PAGE | | SAFETY NOTICE II | | | | | INTRODUCTION III | | | | | 01 MAINTENANCE | | 01-Table of Contents 01-01-1
02-Periodic Inspection Chart 01-02-1
03-Flushing and Lubrication 01-03-1
04-Water-Flooded Engine 01-04-1
05-Storage 01-05-1 | | | 02 TROUBLESHOOTING ........................................................................................................................................ 02-01-1 | | | | | 03 ENGINE | | 01-Table of Contents 03-01-1
02-Engine Leak Test 03-02-1
03-Removal and Installation 03-03-1
04-Magneto System 03-04-1
05-Top End 03-05-1
06-Bottom End 03-06-1
07-Rotary Valve 03-07-1
08-Exhaust System 03-08-1 | | | 04 COOLING SYSTEM | | 01-Table of Contents 04-01-1
02-Components 04-02-1
03-Circuit 04-03-1 | | | 05 FUEL SYSTEM | | 01-Table of Contents 05-01-1
02-Fuel Circuit 05-02-1
03-Air Intake 05-03-1
04-Carburetors 05-04-1 | | | 06 LUBRICATION SYSTEM | | 01-Table of Contents 06-01-1
02-Oil Injection System 06-02-1
03-Oil Injection Pump 06-03-1 | | | 07 ELECTRICAL SYSTEM | | 01-Table of Contents 07-01-1
02- Ignition System 07-02-1
03-Charging System 07-03-1
04-Starting System 07-04-1
05- Instruments and Accessories 07-05-1
06-Digitally Encoded Security System 07-06-1 | | | 08 PROPULSION SYSTEM | | 01-Table of Contents 08-01-1
02-Jet Pump 08-02-1
03-Drive System 08-03-1
04-Reverse System 08-04-1
05-Variable Trim System 08-05-1 | | | 09 STEERING SYSTEM | | 01-Table of Contents 09-01-1
02-SP and SPX Models 09-02-1
03-GTS Model 09-03-1
04-GS, GSI, GSX, GTI and GTX Models 09-04-1
05-XP and HX Models 09-05-1
06-Alignment 09-06-1 | | | 10 SUSPENSION | | 01-Table of Contents 10-01-1
02-Direct Action Suspension 10-02-1 | | | 11 HULL/BODY | | 01-Table of Contents 11-01-1
02-Adjustment and Repair 11-02-1 | | | 12 TECHNICAL DATA | | 01-SP and SPX Models 12-01-1
02-GS and GSI Models 12-02-1
03-GSX Model 12-03-1
04-GTS Model 12-04-1
05-GTI and GTX Models 12-05-1
06-HX and XP Models 12-06-1 | | | 13 WIRING DIAGRAMS .......................................................................................................................................... 13-01-1 | | | | I [www.SeaDooManuals.net](www.SeaDooManuals.net) SAFETY NOTICE SAFETY NOTICE This manual was primarily published to be used by watercraft technicians trained by the manufacturer who are already familiar with all service and maintenance procedures relating to Bombardier made SeaDoo watercraft. Please note that the instructions will apply only if proper hand tools and special service tools are used. It is understood that this manual may be translated into another language. In the event of any discrepancy, the English version shall prevail. The content depicts parts and/or procedures applicable to the particular product at its time of manufacture. It does not include dealer modifications, whether authorized or not by Bombardier, after manufacturing the product. The use of Bombardier parts is most strongly recommended when considering replacement of any component. Dealer and / or distrib

FAQs

Who is this shop manual intended for?

It is primarily published for watercraft technicians trained by the manufacturer who are already familiar with service and maintenance procedures for Bombardier Sea-Doo watercraft.

What tools should be used to follow the instructions correctly?

The instructions apply only when proper hand tools and special service tools are used.

What do the manual’s warning and caution symbols mean?

A warning identifies instructions that could cause serious personal injury, including possible death. A caution identifies instructions that could severely damage watercraft components.

Oct 23, 2026

Upload by lilac