[{"data":1,"prerenderedAt":-1},["ShallowReactive",2],{"detail-sidebar-cat-0-en-105":3,"doc-seo-661669-105":59,"doc-detail-661669-en":130},{"code":4,"msg":5,"data":6},0,"success",[7,13,18,23,28,33,38,43,48,51,55],{"id":8,"doc_module":4,"doc_module_name":9,"category_name":10,"show_sort_weight":11,"slug":12},1,"Document","Story & Novel",90,"story-novel",{"id":14,"doc_module":4,"doc_module_name":9,"category_name":15,"show_sort_weight":16,"slug":17},2,"Literature",80,"literature",{"id":19,"doc_module":4,"doc_module_name":9,"category_name":20,"show_sort_weight":21,"slug":22},4,"Exam",70,"exam",{"id":24,"doc_module":4,"doc_module_name":9,"category_name":25,"show_sort_weight":26,"slug":27},5,"Comic",60,"comic",{"id":29,"doc_module":4,"doc_module_name":9,"category_name":30,"show_sort_weight":31,"slug":32},6,"Technology",50,"technology",{"id":34,"doc_module":4,"doc_module_name":9,"category_name":35,"show_sort_weight":36,"slug":37},7,"Healthcare",40,"healthcare",{"id":39,"doc_module":4,"doc_module_name":9,"category_name":40,"show_sort_weight":41,"slug":42},8,"Research & Report",30,"research-report",{"id":44,"doc_module":4,"doc_module_name":9,"category_name":45,"show_sort_weight":46,"slug":47},9,"Religion & Spirituality",20,"religion-spirituality",{"id":46,"doc_module":4,"doc_module_name":9,"category_name":49,"show_sort_weight":46,"slug":50},"World Cup","world-cup",{"id":52,"doc_module":4,"doc_module_name":9,"category_name":53,"show_sort_weight":52,"slug":54},10,"Lifestyle","lifestyle",{"id":56,"doc_module":4,"doc_module_name":9,"category_name":57,"show_sort_weight":24,"slug":58},19,"General","general",{"code":4,"msg":60,"data":61},"ok",{"site_id":62,"language":63,"slug":64,"title":65,"keywords":66,"description":67,"schema_data":68,"social_meta":123,"head_meta":125,"extra_data":127,"updated_unix":129},105,"en","weber-gas-go-anywhere-gas-grill-assembly-and-safety-instructions","Weber Gas Go - Anywhere Gas Grill Assembly and Safety Instructions","","Anywhere Gas Go contains installation and operating instructions for a propane gas grill, including a parts checklist, step-by-step leg and hardware installation, burner tube and regulator setup, and igniter calibration for safe ignition. It also provides safety warnings about adjusting the igniter tip, preventing gas buildup, checking for leaks using a soap-water solution, and verifying connections. Procedures cover safe transport and use, connecting a cylinder, lighting by igniter or manual match, and basic grill care and cleaning guidance.",{"@graph":69,"@context":122},[70,84,105],{"@type":71,"itemListElement":72},"BreadcrumbList",[73,77,79,82],{"item":74,"name":75,"@type":76,"position":8},"https://docshare.wps.com","Home","ListItem",{"item":78,"name":9,"@type":76,"position":14},"https://docshare.wps.com/document/",{"item":80,"name":35,"@type":76,"position":81},"https://docshare.wps.com/document/healthcare/",3,{"item":83,"name":65,"@type":76,"position":19},"https://docshare.wps.com/document/weber-gas-go-anywhere-gas-grill-assembly-and-safety-instructions/661669/",{"url":83,"name":65,"@type":85,"image":86,"author":91,"headline":65,"publisher":94,"fileFormat":97,"inLanguage":63,"description":67,"dateModified":98,"datePublished":99,"encodingFormat":97,"isAccessibleForFree":100,"interactionStatistic":101},"DigitalDocument",{"url":87,"@type":88,"width":89,"height":90},"https://docshare.wps.com/thumbnails/weber-gas-go-anywhere-gas-grill-assembly-and-safety-instructions/661669.png","ImageObject",300,407,{"name":92,"@type":93},"LangkahRina","Person",{"url":74,"name":95,"@type":96},"DocShare","Organization","application/pdf","2026-10-30","2026-10-28",true,{"@type":102,"interactionType":103,"userInteractionCount":19},"InteractionCounter",{"@type":104},"ViewAction",{"@type":106,"mainEntity":107},"FAQPage",[108,114,118],{"name":109,"@type":110,"acceptedAnswer":111},"What should be checked after installing the igniter?","Question",{"text":112,"@type":113},"Adjust the igniter wire tip so it is approximately 1/8 inch from the holes in the burner tube, and confirm it is aligned to avoid gas accumulation during ignition.","Answer",{"name":115,"@type":110,"acceptedAnswer":116},"How should gas leaks be checked?",{"text":117,"@type":113},"Do not use an open flame. Mix detergent with water, wet the connection between tank and regulator, and look for bubbles that indicate a leak.",{"name":119,"@type":110,"acceptedAnswer":120},"What are the steps to light the gas grill safely?",{"text":121,"@type":113},"Remove the lid before lighting. Set the burner control valve to HIGH, press the igniter button 2–3 times, then check ignition through the viewing hole; if it does not light, turn OFF and wait 5 minutes before trying again.","https://schema.org",{"og:url":83,"og:type":124,"og:title":65,"og:site_name":95,"og:description":67},"article",{"robots":126,"canonical":83},"index,follow",{"doc_id":128,"site_id":62},661669,1793174835,{"code":4,"msg":5,"data":131},{"doc_id":128,"user_id":132,"nickname":92,"user_avatar":133,"doc_module":4,"category_id":34,"category_name":35,"doc_title":65,"doc_description":67,"doc_content":134,"file_id":135,"file_url":136,"file_type":137,"file_size":138,"view_count":19,"is_deleted":4,"is_public":8,"is_downloadable":8,"audit_status":8,"page_count":139,"language":140,"language_code":63,"site_id":62,"html_lang":63,"table_of_contents":141,"faqs":142,"seo_title":143,"seo_description":67,"update_tm":129,"read_time":41},962090893776,"https://ap-avatar.wpscdn.com/davatar_155a257f0dc6eb9ab79c44ca47cae57d","Anywhere  \nGas Go  \n®  \nFOR OUTDOOR USE ONLY  \nThis grill does not include an LP fuel tank.  \nCheck Package Contents  \nYou should have received the parts listed below. While  \nwe give much attention to out product, unfortunately an occasional error may occur. If a part is missing, do not go back to the store. Call WeberStephen Products Customer Service Center toll free 1-800-446-1071 to receive immediate assistance.  \n1-Bottom unit assembly  \n1-Lid assembly  \n1-Cooking grate  \n1-Flavorizer Bar  \n1-Burner tube  \n1-Regulator assembly  \n1-Retaining clip (on regulator)  \n2-Legs  \n|  |  |  |  |\n| --- | --- | --- | --- |\n|  |  |  |  |\n|  |  |  |  |\n|  |  |  |  |\n|  |  |  |  |\n|  |  |  |  |\n| 1 | - Leg Lock |  | |\n|  |  |  |  |\n|  |  |  |  |\n| 1 | - 1/4-20 wing | nut | |\n\n1-5/16”Washer   \n1-1/4-20 x 1/2 bolt   \n2-10-24 screws   \n2-10-24 wing nuts   \n6-1/4” Flat washers   \n1- Igniter  \n3  \nInstall Legs  \nPlace washers on leg ends and insert ends into holes in bottom unit. Be careful not to scratch the porcelain finish while installing the legs. Repeat with other leg.  \nInstall Leg Lock  \nPosition curved end of leg lock at corner of the straight portion of the leg, as  \nshown. Push until it snaps on.  \nPosition legs and secure leg lock  \nSwing legs around so that the rounded part sets on the ground and the bottom of the cooking box rests on the straight part of the legs.  \nTo lock the legs in place turn the leg lock around clipping it over the opposite leg. (Unlock the legs by unlatching this clip in the reverse direction.)  \n4  \nInstall Burner Tube  \nFrom the inside, insert burner tube through the large hole in the side of the bottom unit. Line up the other end of the tube with the hole. Insert the 1/2 inch bolt. Add the washer and wing nut. Tighten.  \nInstall Regulator  \nRemove the retaining clip from the regulator. Attach regulator assembly by inserting the brass fitting into the end of the burner tube.. Secure regulator assembly by installing the retaining clip in the square openings on both sides of the burner tube.  \nInstall Igniter  \nInsert the igniter electrode and two 10-24 screws through the igniter bracket and the holes in the bottom unit on the side opposite the regulator.  \nAdd washers and wing nuts, making sure that the wing nuts are secured ina vertical position.  \nThe igniter electrode has been pre-bent. It may need to be adjusted so the tip is approximately 1/8 inch from the holes in the burner tube.  \n􀀂 DANGER  \nMake sure the tip of the igniter wire is adjusted to the holes in the burner tube. If it is not adjusted properly, gas can accumulate in the barbecue while igniting the barbecue. Delayed ignition of the accumulated gas may occur. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.  \nInstall Flavorizer Bar  \nPlace the Flavorizer Bar in bottom unit, covering the burner.  \n~~ Install Cooking Grate ~~  \n~~ Set the cooking grate onto the recessed edge of the bottom unit~~.~~ ~~  \nTo Secure for Transport  \nPut the lid on the bottom unit unlock legs and pivot them into the locked position up over the projections on the lid.  \nTo Use  \n~~ Pivot legs under grill and lock legs. The hooks on the inside of the lid allow it   to rest on the edge of the bottom unit. ~~  \nRead important DANGERS, WARNINGS and CAUTIONS in Owner’s Guide before operating this barbecue.  \nConnecting the Cylinder  \n1. Lubricate the threads of the regulator assembly with petroleum jelly.  \n2. Make sure the burner control valve is in the LOCK/OFF position before attaching the propane cylinder. Valve closes by turning the knob clockwise to the LOCK/OFF position.  \n3. Attach the propane cylinder to the grill by pushing the cylinder slightly while turning clockwise into the regulator. Turn until a snug fit is obtained.  \nCheck for Gas Leaks  \n􀀂 DANGER  \nDo not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will r","cbCaigBq34xN2MoM","https://ap.wps.com/l/cbCaigBq34xN2MoM","pdf",227418,12,"English","# Check Package Contents\n## Install Legs and Leg Lock\n## Install Burner Tube and Regulator\n## Install Igniter and Flavorizer Bar\n## To Secure for Transport and To Use\n## Connecting the Cylinder\n## Check for Gas Leaks\n## Lighting Your Gas Grill\n## Manual Lighting\n## Gas Grill Care","[{\"question\":\"What should be checked after installing the igniter?\",\"answer\":\"Adjust the igniter wire tip so it is approximately 1/8 inch from the holes in the burner tube, and confirm it is aligned to avoid gas accumulation during ignition.\"},{\"question\":\"How should gas leaks be checked?\",\"answer\":\"Do not use an open flame. Mix detergent with water, wet the connection between tank and regulator, and look for bubbles that indicate a leak.\"},{\"question\":\"What are the steps to light the gas grill safely?\",\"answer\":\"Remove the lid before lighting. Set the burner control valve to HIGH, press the igniter button 2–3 times, then check ignition through the viewing hole; if it does not light, turn OFF and wait 5 minutes before trying again.\"}]","Weber Gas Go - Anywhere Gas Grill Assembly and Safety Instructions | PDF"]