[{"data":1,"prerenderedAt":-1},["ShallowReactive",2],{"detail-sidebar-cat-0-en-105":3,"doc-seo-662158-105":59,"doc-detail-662158-en":130},{"code":4,"msg":5,"data":6},0,"success",[7,13,18,23,28,33,38,43,48,51,55],{"id":8,"doc_module":4,"doc_module_name":9,"category_name":10,"show_sort_weight":11,"slug":12},1,"Document","Story & Novel",90,"story-novel",{"id":14,"doc_module":4,"doc_module_name":9,"category_name":15,"show_sort_weight":16,"slug":17},2,"Literature",80,"literature",{"id":19,"doc_module":4,"doc_module_name":9,"category_name":20,"show_sort_weight":21,"slug":22},4,"Exam",70,"exam",{"id":24,"doc_module":4,"doc_module_name":9,"category_name":25,"show_sort_weight":26,"slug":27},5,"Comic",60,"comic",{"id":29,"doc_module":4,"doc_module_name":9,"category_name":30,"show_sort_weight":31,"slug":32},6,"Technology",50,"technology",{"id":34,"doc_module":4,"doc_module_name":9,"category_name":35,"show_sort_weight":36,"slug":37},7,"Healthcare",40,"healthcare",{"id":39,"doc_module":4,"doc_module_name":9,"category_name":40,"show_sort_weight":41,"slug":42},8,"Research & Report",30,"research-report",{"id":44,"doc_module":4,"doc_module_name":9,"category_name":45,"show_sort_weight":46,"slug":47},9,"Religion & Spirituality",20,"religion-spirituality",{"id":46,"doc_module":4,"doc_module_name":9,"category_name":49,"show_sort_weight":46,"slug":50},"World Cup","world-cup",{"id":52,"doc_module":4,"doc_module_name":9,"category_name":53,"show_sort_weight":52,"slug":54},10,"Lifestyle","lifestyle",{"id":56,"doc_module":4,"doc_module_name":9,"category_name":57,"show_sort_weight":24,"slug":58},19,"General","general",{"code":4,"msg":60,"data":61},"ok",{"site_id":62,"language":63,"slug":64,"title":65,"keywords":66,"description":67,"schema_data":68,"social_meta":123,"head_meta":125,"extra_data":127,"updated_unix":129},105,"en","dynamic-line-4-instructions-for-use-installation-servo-motors-dl4","DYNAMIC LINE 4 - Instructions for Use - Installation Servo Motors DL4","","Installation manual for KEB DYNAMIC LINE 4 equipment covering installation of DL4 servo motors. Provides safety signal words and symbol conventions used throughout the document, including dangerous situation warnings and property-damage restrictions. Summarizes legal and guideline information, warranty and liability references, and support responsibilities. Includes copyright and trademark notices and a structured table of contents entry points for related sections such as standards, glossary, figure and table lists.",{"@graph":69,"@context":122},[70,84,105],{"@type":71,"itemListElement":72},"BreadcrumbList",[73,77,79,82],{"item":74,"name":75,"@type":76,"position":8},"https://docshare.wps.com","Home","ListItem",{"item":78,"name":9,"@type":76,"position":14},"https://docshare.wps.com/document/",{"item":80,"name":30,"@type":76,"position":81},"https://docshare.wps.com/document/technology/",3,{"item":83,"name":65,"@type":76,"position":19},"https://docshare.wps.com/document/dynamic-line-4-instructions-for-use-installation-servo-motors-dl4/662158/",{"url":83,"name":65,"@type":85,"image":86,"author":91,"headline":65,"publisher":94,"fileFormat":97,"inLanguage":63,"description":67,"dateModified":98,"datePublished":99,"encodingFormat":97,"isAccessibleForFree":100,"interactionStatistic":101},"DigitalDocument",{"url":87,"@type":88,"width":89,"height":90},"https://docshare.wps.com/thumbnails/dynamic-line-4-instructions-for-use-installation-servo-motors-dl4/662158.png","ImageObject",300,407,{"name":92,"@type":93},"Cipher","Person",{"url":74,"name":95,"@type":96},"DocShare","Organization","application/pdf","2026-10-29","2026-10-28",true,{"@type":102,"interactionType":103,"userInteractionCount":8},"InteractionCounter",{"@type":104},"ViewAction",{"@type":106,"mainEntity":107},"FAQPage",[108,114,118],{"name":109,"@type":110,"acceptedAnswer":111},"What safety warnings are used in the DL4 installation instructions?","Question",{"text":112,"@type":113},"Safety warnings are marked with defined warning signs describing dangerous situations and possible consequences such as death or minor injury, as well as warnings about property damage.","Answer",{"name":115,"@type":110,"acceptedAnswer":116},"Where can the EC declaration of conformity be obtained?",{"text":117,"@type":113},"The EC declaration of conformity can be downloaded on demand via the KEB Automation website.",{"name":119,"@type":110,"acceptedAnswer":120},"How does the manual address warranty, liability, and support?",{"text":121,"@type":113},"Warranty and liability for design, material, and workmanship are given in KEB general sales conditions, and additional information for unreferenced cases can be requested from the local KEB agency.","https://schema.org",{"og:url":83,"og:type":124,"og:title":65,"og:site_name":95,"og:description":67},"article",{"robots":126,"canonical":83},"index,follow",{"doc_id":128,"site_id":62},662158,1793202449,{"code":4,"msg":5,"data":131},{"doc_id":128,"user_id":132,"nickname":92,"user_avatar":133,"doc_module":4,"category_id":29,"category_name":30,"doc_title":65,"doc_description":67,"doc_content":134,"file_id":135,"file_url":136,"file_type":137,"file_size":138,"view_count":8,"is_deleted":4,"is_public":8,"is_downloadable":8,"audit_status":8,"page_count":139,"language":140,"language_code":63,"site_id":62,"html_lang":63,"table_of_contents":141,"faqs":142,"seo_title":143,"seo_description":67,"update_tm":129,"read_time":144},687208528416,"https://ap-avatar.wpscdn.com/davatar_9964176cb1d06d4a9deccf72a44ae3dc","DYNAMIC LINE 4  \nINSTRUCTIONS FOR USE | INSTALLATION SERVO MOTORS DL4  \nSIZE SE...SG  \nTranslation of original manual Document 20220629 EN 06  \nPREfAcE  \n\n| |  |\n| --- | --- |\n\nPreface  \nThe hardware and software described in this document are products of KEB. The information contained in this document is valid at the time of publishing. KEB reserves the right to update this document in response to misprints, mistakes or technical changes.  \nSignal words and symbols  \nCertain procedures within this document can cause safety hazards during the installation or operation of the device. Refer to the safety warnings in this document when performing these procedures. Safety signs are also located on the device where applicable. A safety warning is marked by one of the following warning signs:  \nDangerous situation, which will cause death or serious injury iif this safety warning is ignored.  \nDangerous situation, which may cause death or serious injury if this safety warning is ignored.  \nDangerous situation, which may cause minor injury if this safety warning is ignored.  \nSituation, which can cause damage to property if this safety warning is ignored.  \nRESTRICTION  \nUsed when the following statements depend on certain conditions or are only valid for certain ranges of values.  \nUsed for informational messages or recommended procedures.  \nMore symbols  \n► This arrow starts an action step.  \n• / - Enumerations are marked with dots or indents.  \n=> Cross reference to another chapter or another page.  \nNote to further documentation.  \n[https://www.keb-automation.com/search](https://www.keb-automation.com/search)  \nPREfAcE  \nLaws and guidelines  \nKEB Automation KG confirms with the EC declaration of conformity and the CE mark on the device nameplate that it complies with the essential safety requirements.  \nThe EC declaration of conformity can be downloaded on demand via our website.  \nWarranty and liability  \nThe warranty and liability on design, material or workmanship for the acquired device is given in the general sales conditions.  \nHere you will find our general sales conditions.  \n[https://www.keb-automation.com/terms-conditions](https://www.keb-automation.com/terms-conditions)  \nFurther agreements or specifications require a written confirmation.  \nSupport  \nAlthough multiple applications are referenced, not every case has been taking into account. If you require further information or if problems occur which are not referenced in the documentation, you can request the necessary information via the local KEB agency.  \nThe use of our units in the target products is outside of our control and therefore lies exclusively in the area of responsibility of the customer.  \nThe information contained in the technical documentation, as well as any user-specific advice in spoken and written and through tests, are made to best of our knowledge and information about the intended use. However, they are regarded as being only informal and changes are expressly reserved, in particular due to technical changes. This also applies to any violation of industrial property rights of a third-party. Selection of our units in view of their suitability for the intended use must be done generally by the user.  \nTests can only be done within the intended end use of the product (application) by the customer. They must be repeated, even if only parts of hardware, software orthe unit adjustment are modified.  \ncopyright  \nThe customer may use the instructions for use as well as further documents or parts from it for internal purposes. Copyrights are with KEB and remain valid in its entirety. This KEB product or parts thereof may contain third-party software, including free and/ or open source software. If applicable, the license terms of this software are contained in the instructions for use. The instructions for use are already available to you, can be downloaded free of charge from the KEB website or can be requested from the respective KEB contact person","cbCainKtZbgalTld","https://ap.wps.com/l/cbCainKtZbgalTld","pdf",2497107,88,"English","# Preface\n# Signal words and symbols\n# More symbols\n# Laws and guidelines\n# Warranty and liability\n# Support\n# Copyright\n# Table of contents\n# List of figures\n# List of Tables\n# Glossary\n# General standards\n# Standards for a","[{\"question\":\"What safety warnings are used in the DL4 installation instructions?\",\"answer\":\"Safety warnings are marked with defined warning signs describing dangerous situations and possible consequences such as death or minor injury, as well as warnings about property damage.\"},{\"question\":\"Where can the EC declaration of conformity be obtained?\",\"answer\":\"The EC declaration of conformity can be downloaded on demand via the KEB Automation website.\"},{\"question\":\"How does the manual address warranty, liability, and support?\",\"answer\":\"Warranty and liability for design, material, and workmanship are given in KEB general sales conditions, and additional information for unreferenced cases can be requested from the local KEB agency.\"}]","DYNAMIC LINE 4 - Instructions for Use - Installation Servo Motors DL4 | PDF",222]